消声元件安装位置对消声效果的影响

分别以消声量和管口阶次噪声作为评价指标,研究消声元件安装位置对消声效果的影响规律,设计在直管不同位置安放四分之一波长管的消声量测量试验对消声量评价。结果表明:设计频率声模态下,在反节点处安装波长管消声量最大,与理论分析完全吻合;进一步对消声量进行仿真计算,结果与试验完全相符。对于管口噪声指标评价,设计频率为267 Hz的谐振腔解决某发动机4000 r/min时进气管口存在4阶噪声引起的噪声峰值问题,对比谐振腔安装在进气管路该频率附近的声模态反节点和节点位置的管口4阶噪声,可知谐振腔布置在反节点位置比节点位置噪音降低了24 dB。两个案例充分证明声学系统模态反节点位置是消声元件的最佳布置位置。     

双盘式磁力耦合器振动噪声分析与实验研究

为了在双盘式磁力耦合器设计阶段分析振动噪声特性,优化双盘式磁力耦合器设计,提出了一种利用模态叠加原理来分析其振动噪声的方法。双盘式磁力耦合器具有高转矩密度与高效率等优势,因此逐渐发展成为煤矿机械柔性传动装置。由于双盘式磁力耦合内部的转子磁场非正弦分布以及涡电流谐波等因素影响,双盘式磁力耦合器输出转矩中不可避免的存在波动。若根据计算得出的双盘式磁力耦合器的电磁振动噪声特点,在设计时选取振动噪声小的参数进行优化组合,可在实际中降低其电磁振动及噪声,有利于减少制造成本。本文结合双盘式磁力耦合器的结构特征,提出了一种模态叠加响应法计算电磁振动噪声,建立了其电磁径向力的解析模型,并在多物理场耦合作用下分析主要电磁径向力波在工作频率内的谐波响应,最后在额定功率为55 kW双盘式磁力耦合器实验台上进行试验验证。基于麦克斯韦张量法,建立了双盘式磁力耦合器的径向电磁力解析模型,并得出0阶与10阶电磁径向力波是产生振动噪声的最主要原因;利用多物理场耦合分析法进行谐波响应NVH特性分析,结果显示0阶力波的振动加速度与形变量均大于10阶力波的振动加速度与形变量,因此双盘式磁力耦合器的电磁振动主要来源于0阶力波;在额定功率为55 kW,最高转速为1 500 r/min的双盘式磁力耦合器实验台进行振动测试,试验结果显示在1 500 r/min时,试验得出的最大振动峰值及频率约为35 m/s^2和4 950 Hz,与有限元仿真结果的误差对应为6.3%和1.1%;而当变频电机的输入转速依次增大时,振动加速度的理论值、仿真值与试验值的曲线形态较为接近,误差较小;噪声估计值与实测值的最大误差仅为8.9%,基本验证了本文所提出模态叠加法的正确性。     

非高斯噪声激励下非线性漂移Fokker-Planck方程的非稳态解及其应用

非高斯噪声广泛存在于各种非线性系统，对非高斯噪声所驱动系统的非稳态演化行为进行研究可以更为深入的了解其内在的演化机理．本文对非高斯噪声和高斯白噪声共同驱动的非线性动力学系统的非稳态演化问题进行研究．首先应用格林函数的 $\Omega$ 展开理论在初始区域对非线性动力学系统进行线性化，然后结合本征值和本征矢理论推导出了该系统 Fokker-Planck 方程的近似非稳态解的表达式，最后以 Logistic 系统模型为例分析了非高斯噪声强度，关联时间及非高斯噪声偏离参数对非稳态解以及一阶矩的影响．研究结果表明，用 Logistic 模型描述产品产量增长时，其非稳态解可更好地反映产品产量在不稳定点附近的演化行为．     

Stochastic stabilization and destabilization of nonlinear and time‐varying hybrid systems by noise

The aim of this article is to design a suitable strength function g(t,x,r(t)) such that the Wiener noise g(t,x(t),r(t))dw(t) either stabilizes or destabilizes a given nonlinear and time‐varying hybrid system . To this end, the basic properties, including the existence and uniqueness of the local and global solutions and the nonzero property of solutions of the nonlinear and time‐varying hybrid stochastic systems, are first investigated as the theoretical basis of the article. Second, two theorems and the corresponding corollaries on the stability and instability of the hybrid stochastic systems are established. Third, the design method for the noise strength g(t,x,r(t)) is then proposed based on the established theorems. We also point out that the Markov jump r(t) may have a stabilizing (respectively, destabilizing) effect when we design the noise strength g(t,x,r(t)) so that the introduced noise g(t,x(t),r(t))dw(t) stabilizes (respectively, destabilizes) the corresponding hybrid system. Finally, we illustrate our method using two examples. Compared with the existing literature, our method is suitable for a wider class of nonlinear and time‐varying systems with weaker conditions than quasi‐linear systems.     

Kernel-based fourth-order diffusion for image noise removal

The fourth-order partial differential equations have good performance on noise smoothing and edge preservation without creating blocky effects on smooth regions. However, for low signal-to-noise ratio images, the discrimination between edges and noise is a challenging problem. A novel kernel-based fourth-order diffusion is proposed in this paper. It introduces a kernelized gradient operator in the fourth-order diffusion process, which leads to more effective noise removal capability. Experiment results show that this method outperforms several previous anisotropic diffusion methods for noise removal and edge preservation.     

Development of low-noise drag-type vertical wind turbines

In this study, the aerodynamic noise characteristics of Savonius wind turbines were investigated using hybrid computational aero-acoustics techniques, and low-noise designs were proposed based on the understanding of the noise generation mechanism. First, the flow field around the turbine was analyzed in detail by solving three-dimensional unsteady incompressible Reynolds-averaged Navier–Stokes equations using computational fluid dynamics techniques. Then, the aerodynamic noise radiating from the wind turbine was predicted using the Ffowcs Williams and Hawkings equation with the obtained flow field information. Two distinct harmonic noise components—the blade passing frequency (BPF) and harmonics with a fundamental frequency that is much higher than the BPF—were identified in the predicted noise spectrum. The origin of the higher harmonic components was found to be related to vortex shedding from the rotating turbine. Based on this finding, the proposed low-noise design for Savonius wind turbines uses S-shaped blades. S-shaped blades were found to reduce the noise levels of Savonius wind turbines by up to 2.7 dB.     

Random-valued impulse noise removal using adaptive dual threshold median filter

Noise detection and its removal is very important in the image processing. Detection of noise is very crucial and significant in random valued impulse noise because it does not hamper the image pixels uniformly. This paper presents a novel and unique concept of adaptive dual threshold for the detection of random valued impulse noise along with simple median filter at noise removal stage. Simulation results shows that an efficient noise detection leads to a superior quality of de-noised image as compared to existing adaptive threshold based image de-noising techniques. Proposed threshold computation is based on averaging of pixel values of window which enhances the PSNR of our system as compared to existing median filter based image de-noising methods.     

Background and foreground interaction: Influence of complementary colors on the search task

Labels are indispensable visual (communication) elements that completely deliver the geospatial message of maps. The objective of this study is to investigate the impact of complementary colors between the map's background and text on the readability of cartographic texts and thus on the efficiency of the map user's search task. This is compared with the use of the “traditional” black labels on the corresponding colored backgrounds. Furthermore, a number of user characteristics, such as gender and expertise, are taken into account as well. The users' eye movements were registered to study their attentive behavior during the visual search task. In addition to the complement of the color's hue, the analyses were based on the difference in luminance, which could also affect the labels' readability. The difference between the black and colored label design was significantly different versus the eye‐tracking metrics. A correlation was found between the color difference and reaction time measurement and between the luminance difference and fixation duration. © 2014 Wiley Periodicals, Inc. Col Res Appl, 40, 437–445, 2015     

Effect of thermal noise on random lasers in diffusion regime

In this paper, we study the effects of thermal noise on the time evolution of a weak light pulse (probe) in the presence of a strong light pulse (pump) within a gain medium which includes random scatterer particles. Suitable thermal noise term is added to a set of four coupled equations including three diffusion equations for energy densities and a rate equation for the upper level population in a four-level gain medium. These equations have been solved simultaneously by Crank–Nicholson numerical method. The main result is that the back-scattered output probe light is increased as the thermal noise strength is increased and simultaneously, with the same rate, the amplified spontaneous emission is decreased. Therefore, the amplified response of the random laser in diffusion regime for the input probe pulse is enhanced due to effect of the thermal noise.